Korg M50 Uživatelský manuál stáhnout pdf (Strana 11)

Setting up the M50 Plug-In Editor

If you want to use the M50 Editor with the M50 connected to your computer via USB, you

must make sure that you have finished installing and setting-up the KORG USB-MIDI Driver

before you start up the M50 Editor.

This section explains how to set up the M50 Plug-In Editor in your host application and create

settings so that it will operate correctly.

About the M50 Plug-In Editor

Parameter data is sent and received between the M50 Plug-In Editor and the M50. Unlike typical

plug-in instruments, the M50 Plug-In Editor does not produce an audio signal.

Your M50 will output audio signals when the M50 Plug-In Editor sends it MIDI messages.

If you want to send the M50’s audio signal to an audio track of your host application and use it in

conjunction with a plug-in effect etc., refer to “Using your host application to control the M50’s

audio signal” (

)

p.9)

Note

: Because the M50 Plug-In Editor does not handle audio signals, you can’t insert a plug-in

effect into the channel of the track in which the M50 Plug-In Editor is inserted, or send its audio

signal via a send or bus.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Žádné komentáře

Korg M50 Uživatelský manuál Strana 11